我公司主要生产无机保温砂浆、玻化微珠保温砂浆、珍珠岩保温砂浆、聚苯颗粒保温砂浆、硅酸盐保温砂浆、硅酸镁保温砂浆,欢迎前来选购

详细内容

玻化微珠保温砂浆施工8点注意事项

时间:2016-07-18     作者:www。hdbwsj。com【原创】   阅读


玻化微珠保温砂浆是以玻化微珠为轻质骨料与玻化微珠保温胶粉料按照一定的比例搅拌均匀混合而成的用于外墙内外保温的一种新型无机保温砂浆材料。玻化微珠保温砂浆具有优异的保温隔热性能和防火耐老化性能、不空鼓开裂、强度高、现场施工加水搅拌即可使用。

Vitrified beads insulation mortar on vitrified beads for light aggregate and vitrified beads insulation powder material in accordance with certain proportion of mixture and stir well to internal and external wall thermal insulation material of a new type of inorganic thermal insulation mortar. Vitrified beads insulation mortar with excellent heat preservation and heat insulation and fire resistance to aging performance, no empty drum cracking, high intensity, site construction and water mixing can be used.


一、玻化微珠保温砂浆施工工艺

A, vitrified beads insulation mortar construction technology


1、先将水倒入容器中,再加入粉料,按1kg粉剂:约0.7-0.9kg水的配合比,混合后用电动搅拌器搅拌成均匀、无颗粒的膏糊状,产品静置3-5分钟后,再次搅拌均匀后即可使用。

1, the first to add water into the container, add powder, press 1 kg powder: about 0.7-0.9 kg of water mixture, mix with an electric mixer mixing into a smooth, no particles as paste, products stand for 3-5 minutes, after mix can be used again.


2、用刮刀均匀抹于工作面上,待其24小时干固后,再进行下一道刮涂,同样用刮刀均匀抹于工作面上再抹平;每次刮涂应保持厚度在15mm-20mm为宜(单次最大厚度不超过35mm),待达到设计厚度要求后,自然养护3-7天即可进行下道工序。

2, with scraper, even put on in the work surface after the 24 hours of dry solid, then under a blade coating, wipe again with scraper even put on in the same job surface flat; Each blade coating thickness shall be maintained at 15 mm to 20 mm advisable (single biggest thickness no more than 35 mm), thickness to meet the design requirement, natural curing 3 to 7 days can be next working procedure.


二、玻化微珠保温砂浆施工注意事项:

Second, vitrified beads insulation mortar construction matters needing attention:


1、玻化微珠保温砂浆宜在5℃-40℃的环境下使用。

1, vitrified beads insulation mortar should be at 5 ℃ and 40 ℃ under the environment of use。


2、施工前必须先确认基面的垂直度及平整度。

2, before construction must first confirm the verticality and smoothness.


3、如果胶浆表面已干结,应将结皮剔去不用。

3, if the mucilage surface is hard and crust should be picked.


4、切忌把已干结的胶浆加水混合再用。

4, avoid by all means have stem node of the mucilage water mixed with.


5、面砖饰面系统的增强层可选择使用耐碱加强型网格布或热镀锌钢丝网。

5, brick veneer system enhancement layer can choose to use alkali enhanced grid cloth or hot dip galvanized wire mesh.


6、玻化微珠保温砂浆施工前基层需做界面处理。

6, vitrified beads insulation mortar construction at the grass-roots level to be done before processing interface.


7、搅拌时请使用低速搅拌器。

7, mixing, please use the low speed mixer.


8、玻化微珠保温砂浆运输时注意避免重压。

8, the transport of vitrified beads insulation mortar take care to avoid stress。

以下产品    详细咨询18832673888   进入网站查看详细情况

 

保温砂浆 www.kgb27.com

硅酸盐板

阿里巴巴华东官网

阿里巴巴华东分店 huadong.1688.com


最新评论
请先登录才能进行回复登录
  • 电话直呼

    • 18831662333
    • 销售经理 :
    • 售前咨询 :
    • 售前咨询 :
    • 售后服务 :
    • 售后服务 :
    • 合同签订/施工方案 :
    • 合同签订/施工方案 :
  • 扫一扫,关注旺铺

雅圆涂料官网 鑫益农蛋白饲料有限公司 秒速赛车买大小技巧 东莞市鲁信机械设备有限公司 北京易束景观绿化工程有限公司 山东省博兴县中泰彩板有限公司 潍坊登峰管业有限公司 山东德旭达土工材料有限公司 秒速赛车滚雪球玩法 广东控银实业有限公司